Rear Cross Traffic Alert (RCTA); 360°View Monitor Range; Always confirm the safety of the area- Page 312



Rear Cross Traffic Alert (RCTA)

If there is the possibility of a collision
with an approaching vehicle while
the rear view/rear wide view is
displayed, a warning is displayed on
the center display.
The Rear Cross Traffic Alert (RCTA)
uses rear side radar sensor to detect
vehicles approaching from the rear
left and right sides of the vehicle,
and it assists the driver in checking
the rear of the vehicle while reversing
by flashing the Blind Spot Monitoring
(BSM) warning lights and activating
the warning sound.
Refer to Rear Cross Traffic Alert
(RCTA) on page 4-115.

360°View Monitor Range

1. Cameras
2. Ultrasonic sensors
3. Front/Rear side radar sensors

WARNING

Always confirm the safety of the area
around the vehicle with the mirrors
and directly with your eyes when
driving:

The 360°View Monitor is an auxiliary
device which assists the driver in
checking the safety of the area around
the vehicle.

The shooting range of the cameras and
detection range of the sensors are
limited. For example, the areas in black
at the front and rear of the vehicle
image and the seams where each of
the camera images merge are blind
spots where an obstruction may not be
visible. In addition, the extended
vehicle width lines and projected
vehicle path lines are only to be used
as references, and the images on the
screen may differ from the actual
conditions.

CAUTION



Do not use the 360°View Monitor
under any of the following
conditions.



Icy or snow-covered roads.



Tire chains or a temporary spare
tire is installed.



The front or rear doors are not fully
closed.



The vehicle is on a road incline.



The door mirrors are retracted.



Do not hit the front/rear camera,
front bumper, liftgate, and door
mirrors forcefully. The camera
position or installation angle may
shift.



The cameras are waterproof. Do not
disassemble, modify, or remove a
camera.



The camera cover is made of hard
plastic, therefore do not apply oil
film remover, organic solvents, wax,
or coating agents. If any such agent
gets on the camera cover, wipe it off
using a soft cloth immediately.



Do not rub the camera lens
forcefully, or clean it with an abrasive
or hard brush. Otherwise, it could
scratch the camera lens and
negatively affect the images.

When Driving

i-ACTIVSENSE

4-166

CX-30_8JP5-EA-20K_Edition1_new

2020-7-22 15:50:09