Fig. 4-37; Fig. 4-38- Page 91

CHAPTER 4  DISASSEMBLY AND RE-ASSEMBLY

4-21

(12) Remove the one M3x10 Taptite screw securing the halogen lamp connector plate at the

drive unit side of the fixing unit frame and then loosen the M3x6 screw at the other side.

(13) Lift the right hand end of the heat roller and remove the halogen heater lamp from the heat

roller.

Fig. 4-37

NOTE:

When re-assembling the halogen heater lamp, ensure that the direction of the halogen heater
lamp is correct referring to the figure above.

!

CAUTION:

• 

Never touch the surface of the halogen heater lamp.

• 

When securing the screw to assemble the halogen lamp connector plate, ensure you use
the plastic jig as shown in the figure below to avoid damaging the edge of the halogen
heater lamp.

Fig. 4-38

Halogen heater lamp

Heat roller

Taptite, pan M3x10

Screw, cup M3x6

Halogen heater lamp

Heat roller

Colored side
115V: Yellow
230V: Purple

Halogen lamp
connector plate

Taptite, pan M3x10

Halogen lamp

connector plate

Plastic jig

Halogen heater lamp