Touch .; Resume Embroidering After Turning Off the Machine; Set the main power switch to “I” to turn on - Page 112

OTHER BASIC PROCEDURES 

—————————————————————————————————————————————————————————————————

110

Resume Embroidering After Turning Off the Machine

In either of the following cases, the remaining stitches of the embroidery are stored in the machine’s 
memory.
• If the machine’s power switch is pressed to turn off after stopping embroidering.

Cut the thread before the machine’s main power switch is turned off, otherwise the thread may be pulled 
or may catch when the carriage returns to its initial position after the machine is turned on again.

• If the machine was accidentally turned off, for example, due to a power outage, while it was 

embroidering.
The remainder of the embroidery can be sewn when the machine is turned on again; however, some of 
the stitches that were already sewn may be sewn again.

Note

●

Be careful when going back or forward 
through the stitching since the embroidery 
frame moves at the same time.

1

Set the main power switch to “I” to turn on 
the machine.

2

When the machine is turned on, the opening 
movie is played. Touch anywhere on the 
screen to display the message below.

3

Touch .

X

A message appears, asking if you wish to 
continue embroidering or start a new 
operation.

4

Touch .

1

Touch to continue embroidering.

2

Touch to cancel embroidering and display the 
pattern type selection screen to select a new 
pattern.

X

The embroidering screen displayed before 
the machine was turned off appears.

2

1