Touch ; Deleting short stitches; Specifying the remaining - Page 203

Using the Settings Key

 201

6

—————————————————————————————————————————————————————————————————————————————————————

Deleting short stitches

If embroidery data other than our original patterns 
is used, the pitch may be too small, which may 
result in the thread or the needle breaking. In order 
to prevent this, the machine can be set to delete 
stitches with a fine pitch. Stitches with a pitch less 
than that specified here can be deleted.
When the embroidery machine is purchased, “0.3” 
was selected (delete stitches with a pitch of 0.3 
mm).
The setting to delete short stitches can be specified 
from page 2/5 of the settings screen.

1

Touch 

 and 

 to select the pitch size.

The desired size is displayed.

• A value between 0 and 1 millimeters if the 

units of measurements is set to “mm” (or a 
value between 0 and 0.04 inch if the units 
of measurements is set to “inch”) can be 
specified.

Note

●

If the setting is changed from the previous 
setting, the new setting is only applied to 
the next embroidery.

Specifying the remaining 
length of thread

This setting specifies whether the length of upper 
thread that remains threaded through the needle 
after the thread is trimmed (length of thread passed 
through the eye of the needle) has a standard tail or 
long tail.
When the embroidery machine is purchased, 
“Standard Tail” is selected.
The setting for the remaining length of thread can 
be specified from page 2/5 of the settings screen.

1

Touch 

 and 

 to select the setting.

The desired length is displayed.

• If the machine misses stitches with a 

standard length of thread after it is 
trimmed, select “Long Tail”.

• When using metallic thread, select “Long 

Tail”.

Changing the screen saver 
settings

■

Specifying the length of time until the screen 
saver is displayed

The screen saver is displayed when no machine 
operation is performed for the specified length of 
time.
A setting between “OFF” (0) and “60” minutes 
can be set in 1-minute increments.
When the embroidery machine is purchased, “5 
min” is selected.
The screen saver settings can be specified from 
page 4/5 of the settings screen.