Maintenance and inspection- Page 6

4

BE-0901E-AC-PC• BE-1201B-AC-PC

Maintenance and inspection

Maintenance and inspection of the sewing

machine should only be carried out by a

qualified technician.

Ask your Brother dealer or a qualified

electrician to carry out any maintenance and

inspection of the electrical system.

Turn off the power switch and disconnect the

power cable (do not pull on the cable itself)

from the wall outlet before attempting to

perform the following operations.  Otherwise,

the machine is started if the start switch is

pressed by mistake.    Injury may occur in

such a case.

• When carrying out inspection, adjustment,

or maintenance

• When replacing consumable parts such

as a rotary hook, a knife, or a fluorescent

lamp

If the power switch needs to be left on when

carrying out some adjustment, be extremely

careful to observe all safety precautions.

Use only the proper replacement parts as

specified by Brother.

When replacing a fluorescent lamp, use the

same-type lamp having a rating of 40 watts.

Wait until the fluorescent lamp cools off before

replacement.    Failure to do so can result in

burns.

If any safety devices have been removed, be

absolutely sure to re-install them to their original

positions and check that they operate correctly

before using the machine.

Any problems in machine operation which result

from unauthorized modifications to the machine

will not be covered by the warranty.