Wiring Information (For U.K. only)- Page 16

REGULATIONS

xiv

Wiring Information (For U.K. only)

Important

If the mains plug supplied with this printer is not suitable for your socket outlet, remove the plug from the
mains cord and fit an appropriate three pin plug. If the replacement plug is intended to take a fuse then fit the
same rating fuse as the original.

If a moulded plug is severed from the mains cord then it should be destroyed because a plug with cut wires is
dangerous if engaged in a live socket outlet. Do not leave it where a child might find it!

In the event of replacing the plug fuse, fit a fuse approved by ASTA to BS1362 with the same rating as the
original fuse.

Always replace the fuse cover. Never use a plug with the cover omitted.

WARNING - THIS PRINTER

MUST BE PROPERLY EARTHED.

The wires in the mains cord are colored in accordance with the following code:

Green and yellow:

Earth

Blue: Neutral
Brown: Live

The colours of the wires in the main lead of this printer may not correspond with the colored markings
identifying the terminals in your plug.

If you need to fit a different plug, proceed as follows.

Remove a length of the cord outer sheath, taking care not to damage the colored insulation of the wires inside.

Cut each of the three wires to the appropriate length. If the construction of the plug permits, leave the green and
yellow wire longer than the others so that, in the event that the cord is pulled out of the plug, the green and
yellow wire will be the last to disconnect.

Remove a short section of the colored insulation to expose the wires.

The wire which is colored green and yellow must be connected to the terminal in the plug which is marked with
the letter “E” or by the safety earth symbol 

or colored green or green and yellow.

The wire which is colored blue must be connected to the terminal which is marked with the letter “N” or
colored black or blue.

The wire which is colored brown must be connected to the terminal which is marked with the letter “L” or
colored red or brown.

The outer sheath of the cord must be secured inside the plug. The colored wires should not hang out of the plug.