Appendix A; Using services; Other ways to set the IP address (for advanced users and administrators)- Page 117

110

A

Using services

A

A service is a resource that can be accessed by computers that wish to print to the Brother print server. The 
Brother print server provides the following predefined services (do a SHOW SERVICE command in the 
Brother print server remote console to see a list of available services): Enter 

HELP

 at the command prompt 

for a list of supported commands.

Where 

xxxxxx

 is the last six digits of the Ethernet address (for example, BRN_310107_P1).

Other ways to set the IP address (for advanced users and 

administrators)

A

For information on how to configure your machine for a network using the BRAdmin Professional utility, see 

Setting the IP address and subnet mask

on page 11.

Using DHCP to configure the IP address

A

The Dynamic Host Configuration Protocol (DHCP) is one of several automated mechanisms for IP address 
allocation. If you have a DHCP server in your network, the print server will automatically obtain its IP address 
from DHCP server and register its name with any RFC 1001 and 1002-compliant dynamic name services.

Note

If you do not want your print server configured via DHCP, BOOTP or RARP, you must set the BOOT 
METHOD to static so that the print server has a static IP address. This will prevent the print server from 
trying to obtain an IP address from any of these systems. To change the BOOT METHOD, use the 
BRAdmin Professional utility.

Using BOOTP to configure the IP address

A

BOOTP is an alternative to rarp that has the advantage of allowing configuration of the subnet mask and 
gateway. In order to use BOOTP to configure the IP address make sure that BOOTP is installed and running 
on your host computer (it should appear in the 

/etc/services

 file on your host as a real service; type 

man 

bootpd

 or refer to your system documentation for information). BOOTP is usually started up via the 

/etc/inetd.conf

 file, so you may need to enable it by removing the “#” in front of the bootp entry in that 

file. For example, a typical bootp entry in the /etc/inetd.conf file would be:

#bootp dgram udp wait /usr/etc/bootpd bootpd -i

Depending on the system, this entry might be called “bootps” instead of “bootp”.

Appendix A

A

Service (Example)

Definition

BINARY_P1

TCP/IP binary, NetBIOS service

TEXT_P1

TCP/IP text service (adds carriage return after each line feed)

BRN_xxxxxx_P1

TCP/IP binary