Press - Page 54

Wireless configuration for Windows

®

 using the Brother installer application

45

4

i

Press 

Menu

, 

5

, 

2

, 

3

 for 

SES/WPS/AOSS

.

This feature will automatically detect which mode (SecureEasySetup™, Wi-Fi Protected Setup™ or 
AOSS™) your access point uses to configure your machine.

Note

If your wireless access point supports Wi-Fi Protected Setup™ (PIN Method) and you want to configure 
your machine using the PIN (Personal Identification Number) Method, see 

Using the PIN Method of Wi-Fi 

Protected Setup™

 on page 34.

j

The machine searches for an access point that supports SecureEasySetup™, Wi-Fi Protected Setup™ 
or AOSS™ for 2 minutes.

Setting WLAN

k

Put your access point in the SecureEasySetup™ mode, Wi-Fi Protected Setup™ mode or AOSS™ 
mode, depending on what is supported by your access point. Please refer to the instruction manual that 
came with your access point.

l

If the LCD shows 

Connected

, the machine has successfully connected to your router or access point. 

You can now use your machine in a wireless network.

If the LCD shows 

Incorrect Mode

, session overlap is detected. The machine has detected more than 

one router or access point on your network with the Wi-Fi Protected Setup™ mode or AOSS™ mode 
enabled. Make sure that only one router or access point has the Wi-Fi Protected Setup™ mode or the 
AOSS™ mode enabled and try starting from 

c

 again.

If the LCD shows 

Connection NG

 (or

Connection error)

, the machine has not successfully 

connected to your router or access point. Try starting from 

c

 again. If the same message is indicated 

again, reset the machine back to the default factory settings and try again. For resetting, see 

Restoring 

the network settings to factory default

 on page 87.

If 

Connection NG

 (or 

Connection error

) is shown after 

Setting WLAN

, this may be due to a 

session overlap detection error. The machine has detected more than one router or access point on your 
network with the SecureEasySetup™ mode, Wi-Fi Protected Setup™ mode or AOSS™ mode enabled. 
Make sure that only one router or access point has the SecureEasySetup™ mode, 
Wi-Fi Protected Setup™ mode or AOSS™ mode enabled and try starting from 

c

 again.