Federal Communications Commission (FCC) Declaration of Conformity (For USA Only)- Page 2

INTRODUCTION

Thank you for purchasing the P-touch labeler PT-2730.

Your new P-touch labeler is an easy to operate, feature packed labeling system that 

makes creating professional, high quality labels a breeze. In addition to easy label cre-

ation via pre-formatted label layouts, the P-touch labeler editing software features 

advanced label formatting, block formats, bar codes and auto-numbering functions.

This manual contains various precautions and basic procedures for using this labeler. 

Read this manual carefully before using and keep in a handy place for future reference.

Federal Communications Commission (FCC) Declaration of Conformity (For USA Only)

Responsible Party :  Brother International Corporation

100 Somerset Corporate Boulevard

Bridgewater, NJ 08807-0911 USA

TEL : (908) 704-1700

declares that the products

Product Name : 

Brother P-touch Electronic Labeling System

Model Number : 

PT-2730

comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 

(1) this device may not cause harmful interference, and (2) this device must accept any 

interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This 

equipment generates, uses, and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the user 

is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver 

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Important

• The enclosed interface cable should be used in order to ensure compliance with the limits 

for a Class B digital device.

• Changes or modifications not expressly approved by Brother Industries, Ltd. could void 

the user's authority to operate the equipment.