Universal Transmitter (If Equipped); Programming the Universal Transmitter- Page 115

yellow

blue     

2-58

To vent open the glass panel, press and hold the switch
upward. The sunshade must be opened by hand. To close
the glass panel, pull and hold the switch downward.

Universal Transmitter (If Equipped)

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: 
(1) this device may not cause harmful interference, and 
(2) this device must accept any interference received,
including interference that may cause undesired operation.

This device complies with RSS

-

210 of Industry Canada.

Operation is subject to the following two conditions: 
(1) this device may not cause interference, and (2) this
device must accept any interference, including interference
that may cause undesired operation of the device.

Changes and modifications to this system by other than
an authorized service facility could void authorization to
use this equipment.

Programming the Universal Transmitter

Do not use the Universal Transmitter with any garage
door opener that does not have the “stop and reverse”
safety feature. This includes any garage door opener
model manufactured before April 1, 1982.

Be sure that people and objects are clear of the garage
door you are programming.

Your vehicle’s engine should be turned off while
programming the transmitter. Follow these steps to
program up to three channels:

1. If you have previously programmed a transmitter

channel, proceed to Step 2. Otherwise, hold down
the two outside buttons on the Universal Transmitter
until the indicator light begins to flash rapidly (after
20 seconds). Then release the buttons. This
procedure initializes the memory and erases any
previous settings for all three channels.

2. Decide which one of the three channels you want to

program. Hold the end of the hand

-

held transmitter

about 2 to 5 inches (5 to 13 cm) away from the
surface of the Universal Transmitter so that you can
still see the indicator light.

3. Using both hands, press the hand

-

held transmitter button

and the desired button on the Universal Transmitter.
Continue to press both buttons through Step 4.