Testing the Alarm; PASS-Key III- Page 74

yellow

blue     

2-17

Testing the Alarm

The alarm can be tested by following these steps:

1. From inside the vehicle, roll down the driver’s

window and open the driver’s door.

2. Activate the system by locking the doors with the

power door lock switch while the door is open, or
with the remote keyless entry transmitter.

3. Get out of the car, close the door and wait for the

SECURITY light to go out.

4. Then reach in through the window, unlock the door

with the manual door lock and open the door. 
This should set off the alarm.

If the alarm does not sound when it should, but the
vehicle’s lamps flash, check to see if the horn works.
The horn fuse may be blown. To replace the fuse, see
“Fuses and Circuit Breakers” in the Index.

If the alarm does not sound or the vehicle’s lamps do not
flash, the vehicle should be serviced by an authorized
service center.

PASS

-

Key

R

 III

Your vehicle is equipped
with the PASS

-

Key III

(Personalized Automotive
Security System)
theft

-

deterrent system.

PASS

-

Key III is a passive

theft

-

deterrent system. This

means you don’t have to do
anything different to arm or
disarm the system. It works
when you insert or remove
the key from the ignition.

Your PASS

-

Key III system operates on a radio

frequency subject to Federal Communications
Commission (FCC) Rules and with Industry Canada.

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: 
(1) this device may not cause harmful interference, and 
(2) this device must accept any interference received,
including interference that may cause undesired operation.