Delayed Locking- Page 63

yellow

blue     

2-6

Vehicles are delivered programmed in Mode 3.

Use the following procedure to change modes:

1. Close all the doors and turn the ignition on. 

Keep all doors closed throughout this procedure.

2. Press and hold LOCK on the driver’s power door

lock switch throughout this procedure. All the doors
will lock.

3. Press the button with the lock symbol on the remote

keyless entry transmitter. The automatic door locks
will remain in the current mode.

4. Press the button with the lock symbol on the

transmitter again. Each time this button is pressed,
the mode will advance by one, going from 
3 to 0 to 1, etc.

Note: The door locks will cycle according to the
mode entered while customizing the memory door
locks. (Mode “0” has no feedback.)

5. Release the power door lock switch. The automatic door

locks will remain in the most recent mode selected.

This procedure only changes the mode for the
transmitter used to change this setting. The procedure
will need to be repeated for the second transmitter.

If your vehicle is equipped with the Driver Information
Center (DIC), you must program this feature through the
DIC. See “Driver Information Center” in the Index.

Delayed Locking

This feature lets the driver delay the actual locking of
the vehicle. When the driver’s power door lock switch
or remote keyless entry lock button is pressed with the
key removed from the ignition, and the driver’s door
open, a chime will sound three times to signal that
delayed locking system is active. When all doors have
been closed, the doors will lock automatically after five
seconds. If any door is opened before this, the
five

-

second timer will reset itself once all the doors have

been closed again.

Pressing the driver’s door lock switch or remote keyless
entry transmitter button again will override this feature.
Pressing the passenger’s door lock switch will also
override this feature.