Resynchronization- Page 70

yellow

blue     

2-13

For battery replacement, use one Duracell

R

 battery, type

DL

-

2032, or a similar type.

To replace the battery:

1. Insert a coin into the notch near the key ring. Turn

the coin counterclockwise to separate the two halves
of the transmitter.

2. Once the transmitter is separated, use a pencil eraser

to remove the old battery. Do not use a metal object.

3. Remove and replace the battery. Replace it as the

instructions inside the cover indicate.

4. Snap the transmitter back together tightly to be sure

no moisture can enter.

5. Test the operation of the transmitter with your

vehicle. If the transmitter does not work,
resynchronize the transmitter.

Resynchronization

Pressing the transmitter buttons numerous times
(approximately 250 times) out of the vehicle’s operating
range may cause the transmitter not to work. Replacing
the battery and pressing the transmitter buttons out of
range will also cause the transmitter not to work. If only
the instant alarm works, the transmitter needs to be
resynchronized to the receiver. Resynchronize by
pressing and holding both the buttons with the lock and
unlock symbols at the same time for about eight
seconds. You must be within range of the vehicle.

Once the transmitter has been resynchronized, the locks
will cycle (the horn may chirp and the exterior lamps
may flash) depending on the security feedback settings.
The system should now operate properly.