Jam-safe Window; Power window system initialization- Page 129

NOTE

Power window system initialization
procedure

If you operate the switch any number
of times with the power window not
fully closed, the window may no longer
fully open/close automatically.
The power window auto function will
only resume on a power window that
has been reset.
1. Switch the ignition ON.
2. Make sure that the power window

lock switch located on the driver's
door is not depressed.

3. Press the switch and fully open the

window.

4. Pull up the switch to fully close the

window and continue holding the
switch for about 2 seconds after the
window fully closed.

5. Make sure that the power windows

operate correctly using the door
switches.

▼

Jam-safe Window

When the window is closing and a
foreign object is detected between the
window and the window frame, the
window stops closing and
automatically opens partway.

NOTE



The jam-safe function may operate
under the following conditions:



A strong impact is detected while
the window is closing.



The window is closing in very low
temperatures.



(A window cannot be closed)

If the jam-safe function has operated
and the window cannot be closed,
check around the window frame for
a foreign object.
If there is no foreign object around
the window frame, forcibly close a
window using the following
procedure.
1. After switching the ignition OFF,

wait for 45 seconds or longer.

2. Switch the ignition ON.
3. Operate the switch in the

direction to close the window
until the jam-safe function
operates and the window stops.
Repeat this operation a total of 5
times.

4. Continue pulling up the switch to

fully close the window.

Before Driving

Windows

3-41

CX-30_8JP5-EA-20K_Edition1_new

2020-7-22 15:50:09