Use the tether and tether anchor only; for a child-restraint system:- Page 58

3. Secure the child-restraint system

with the lap portion of the lap/
shoulder belt. See the
manufacturer's instructions on the
child-restraint system for belt
routing instructions.

4. To get the retractor into the

automatic locking mode, pull the
shoulder belt portion of the seat
belt until the entire length of the
belt is out of the retractor.

5. Push the child-restraint system

firmly into the vehicle seat. Be sure
the belt retracts as snugly as
possible. A clicking noise from the
retractor will be heard during
retraction if the system is in the
automatic locking mode. If the belt
does not lock the seat down tight,
repeat this step.

NOTE



Inspect this function before each
use of the child-restraint system.
You should not be able to pull the
shoulder belt out of the retractor
while the system is in the
automatic locking mode. When
you remove the child-restraint
system, be sure the belt fully
retracts to return the system to
emergency locking mode before
occupants use the seat belts.

6. If your child-restraint system

requires the use of a tether strap,
refer to the manufacturer's
instructions to hook and tighten the
tether strap.

WARNING

Use the tether and tether anchor only
for a child-restraint system:

Using the tether or tether anchor to
secure anything but a child-restraint
system is dangerous. This could
weaken or damage the tether or tether
anchor and result in injury.

Essential Safety Equipment

Child Restraint

2-42

CX-30_8JP5-EA-20K_Edition1_new

2020-7-22 15:50:09