Fig. 5-86; Fig. 5-87- Page 177

CHAPTER 5 MAINTENANCE

5-65

4. 

Hold the DIMM with your
fingers on the side edges and
your thumb against the back
edge. Align the notches on the
DIMM with the DIMM slots.
(Check that the locks on each
side of the DIMM slot are open,
or outward.)

Fig. 5-86

5. 

Press the DIMM straight into the slot (press firmly). Make sure the locks
on each side of the DIMM snap inward into place. (To remove a DIMM,
the locks must be released.)

Note

• 

When you install less than two DIMMs, be sure to install them in the
order Slot 1, Slot 2 and then Slot 3.

• 

When you install different capacities of DIMMs, be sure to install the
larger capacity DIMM in Slot 1 and the smaller capacity DIMM in Slot 2
and then Slot 3.

6. 

Refit the main controller board
into the printer by sliding it into
the guide rails.

Fig. 5-87

7. 

Secure the main controller board with the two screws.

8. 

Reconnect the printer cable from your computer. Plug the power cord
into the AC outlet and turn on the printer.

9. 

To check whether the DIMM has been installed correctly, you may
perform a Test Print “Print Configuration” that will print the current
memory size.