FRONT PANEL SETUP 3 - 3- Page 24

FRONT PANEL SETUP 3 - 3

NC9100h_FM6.0

RARP mode

Brother Print/Scan server IP address can be configured using the 
Reverse ARP (RARP) facility on your host computer. This is done by 
editing the /etc/ethers file (if this file does not exist, you can create it) 
with an entry similar to the following:

00:80:77:31:01:07   BRN_310107

Where the first entry is the Ethernet address of the Print/Scan server 
and the second entry is the name of the Print/Scan server (the name 
must be the same as the one you put in the /etc/hosts file).

If the rarp daemon is not already running, start it (depending on the 
system the command can be rarpd, rarpd -a, in.rarpd -a or something 
else; type man rarpd or refer to your system documentation for 
additional information). To verify that the rarp daemon is running on 
a Berkeley UNIX-based system, type the following command:

ps -ax | grep -v grep | grep rarpd

For AT&T UNIX-based systems, type:

ps -ef | grep -v grep | grep rarpd

The Brother Print/Scan server will get the IP address from the rarp 
daemon when it is powered on.