Replacing the cutter unit- Page 26

Maintenance and Troubleshooting

26

Eventually the cutting blade on the cutter unit will become dull and need to be replaced. 

When this happens, purchase a new replacement cutter unit and install it according to 

the following procedure. For assistance in purchasing a replacement cutter unit, refer to 

Î

"Accessories (For USA Only)" on page 30.

1

Check that the cutter unit is located in the home position.

2

Turn OFF the power and pull out the power cord from the wall 

outlet.

3

Open the DK Roll cover and pull the roll 

release lever to the up position. Remove the 

DK Roll.

4

Lift up the cutter cover.

5

Using a Phillips-head screwdriver, loosen 

the screw which holds the cutter blade unit 

in-place.

The screw of cutter unit cannot be removed to 

prevent the malfunction of the printer.

Replacing the cutter unit