Canadian Programming; Operating the HomeLink Transmitter; Erasing Channels- Page 128

2-65

Canadian Programming

Canadian Owners: During programming, the
hand

-

held transmitter may automatically stop

transmitting after two seconds. In this case, you should
press and hold the HomeLink button (see Steps 2 and 3
under “Programming the HomeLink Transmitter”) while
you press and repress (cycle) your hand

-

held transmitter

every two seconds until HomeLink is trained.

Operating the HomeLink Transmitter

Press and hold the appropriate button on HomeLink for
at least a half of a second. The indicator light will come
on while the signal is being transmitted.

Erasing Channels

To erase all three programmed channels, hold down the
two outside buttons on HomeLink until the indicator
light begins to flash (approximately 20 seconds).
Release both buttons.

Resetting Defaults

To reset HomeLink to default settings, hold down the
two outside buttons on HomeLink until the indicator
light begins to flash (approximately 20 seconds).
Continue to hold the buttons until the HomeLink
indicator light turns off and then release both buttons.

Accessories

Accessories for HomeLink are available. If you would
like additional information, please contact the
manufacturer of HomeLink at 1

-

800

-

355

-

3515, 

or on the internet at www.homelink.com.