Personal Choice Comfort Controls (If Equipped); Personal Choice Comfort Controls - Page 164

3-7

Sun and temperature sensors automatically adjust the air
temperature, the airflow direction and the fan speed to
maintain your temperature setting. The system may
supply cooler air to the side of the vehicle toward the
sun. Be careful not to put anything over the sensor on
top of the dash.

The display will show fan speed, temperature level
setting and airflow direction for a few seconds whenever
AUTO is selected, and then it will display the outside
temperature. The outside temperature reading is most
accurate when the vehicle is moving. During stops, the
display shows the previous temperature for best
accuracy and system control.

To find your preferred temperature setting, start with the
system in AUTO mode and the TEMP button adjusted
to 75

_

F (24

_

C), give the vehicle about 20 minutes to

stabilize, and adjust your temperature setting if
necessary, by using the TEMP button. The display will
show the temperature setting for a few seconds and then
it will display the outside temperature. If you want to
see your current automatic fan speed, airflow direction
and temperature setting, press the AUTO button.

In cold weather, the system will delay turning on the fan,
to avoid blowing cold air. During this delay the system
will be in FRONT defrost mode and the light in the button
will come on and stay on as long as the display is showing
the current mode, set TEMP and FAN speed. This light
will go off when the display returns to the outside
temperature. The length of the delay depends on the
engine coolant temperature and the outside temperature.
Pushing the FAN, AIR FLOW or FRONT buttons will
override this delay, turn off the AUTO setting and return
the system to manual operation.

Personal Choice Comfort Controls 
(If Equipped)

This feature enables up to two drivers to store and recall
comfort control settings for the temperature, fan speed
and the direction of the airflow.

The memory buttons (1 or 2) for this feature are located
on the driver’s door panel and correspond to the
numbers (1 or 2) found on the back of each keyless
entry transmitter.

To recall comfort settings, press the unlock button on the
remote keyless entry transmitter and put the ignition in
ACCESSORY or RUN. The climate control setting last
chosen by the identified driver (1 or 2) will be recalled.