Delayed Locking- Page 71

2-8

If your vehicle is equipped with the DIC, you must use
it to program this feature. See “Driver Information
Center (DIC)” in the Index.

If your vehicle is not equipped with the DIC, use the
following procedure to change modes:

1. Close all the doors and turn the ignition on. Keep all

doors closed throughout this procedure.

2. Press and hold LOCK on the driver’s power door

lock switch throughout this procedure. All the doors
will lock.

3. Press the button with the lock symbol on the remote

keyless entry transmitter. The automatic door locks
will remain in the current mode.

4. Press the button with the lock symbol on the

transmitter again. Each time this button is 
pressed, the mode will advance by one, going 
from 3 to 0 to 1, etc.

The door locks will cycle according to the mode
entered while customizing the memory door locks.
(Mode 0 has no feedback.)

5. Release the power door lock switch. The automatic door

locks will remain in the most recent mode selected.

This procedure only changes the mode for the
transmitter used to change this setting. The procedure
will need to be repeated for the second transmitter.

Delayed Locking

This feature lets the driver delay the actual locking of
the vehicle. When the driver’s power door lock switch
or remote keyless entry lock button is pressed with the
key removed from the ignition, and the driver’s door
open, a chime will sound three times to signal that the
delayed locking system is active. When all doors have
been closed, the doors will lock automatically after 
five seconds. If any door is opened before this, the
five

-

second timer will reset itself once all the doors 

have been closed again.

Pressing the driver’s power door lock switch or remote
keyless entry transmitter button again will override this
feature. Pressing the front passenger’s power door lock
switch will also override this feature.