Step 1; Complete the programming within- Page 205

NOTE

Depending on the hand-held
transmitter, it may be easier to do
the programming by holding it 15
to 20 cm (6 to 7.8 in) away from
the HomeLink button.

3. Press the hand-held transmitter

button continuously until the
indicator light changes from amber
(flashing) to green (on/flashing).

NOTE

Some gate operators and garage
door openers may require you to
replace this Programming Step 3
with procedures noted in the “Gate
Operator/Canadian Programming”
section.

4. Press the HomeLink button again to

check if the programming has been
completed.



If the indicator light remains on in
green, the programming is
complete and the device
becomes operational.



If the indicator light flashes
rapidly in green, firmly press and
hold the Homelink button and
release it after two seconds have
passed. Repeat this process up to
three times to complete the
programming. The device
becomes operational and
programming is complete. If the
device does not operate, go to
the next step.

5. At the garage door opener receiver

(motor-head unit) in the garage,
locate the “learn” or “smart” button.
This can usually be found where the
hanging antenna wire is attached to
the motor-head unit.

6. Firmly press and release the “learn”

or “smart” button. (The name and
color of the button may vary by
manufacturer.)

NOTE

Complete the programming within
30 seconds.

7. Return to the vehicle and firmly

press

 and 

hold

 the Homelink

button, and then 

release

 it after

two seconds have passed. Repeat
the “

press/hold/release

” sequence

a second time, and, depending on
the brand of the garage door
opener (or other rolling code
equipped device), repeat this
sequence a third time to complete
the programming process.
Press the programmed HomeLink
button and make sure that the
HomeLink System operates.

8. If the status indicator arrows are

flashing, refer to Garage Door
Two-Way Communication.

1. Indicator light

NOTE

To program the remaining two
HomeLink buttons, go back to 

Step 1

of Programming the HomeLink System
and repeat the procedure.

For questions or comments, please
contact 

HomeLink at

www.homelink.com

 or

www.youtube.com/
HomeLinkGentex

, or the HomeLink

toll-free hotline at 1-800-355-3515
(for calls placed outside of the USA,
Canada, and Puerto Rico, international
rates will apply and may differ based
on landline or mobile phone).

When Driving

Switches and Controls

4-59

CX-30_8JP5-EA-20K_Edition1_new

2020-7-22 15:50:09