Erasing Programmed HomeLink; Garage Door Two-Way- Page 207

▼

Erasing Programmed HomeLink
Buttons

NOTE



All of the programmed HomeLink
buttons are reset. Individual buttons
cannot be reset, however, individual
buttons can be reprogrammed. For
individual button reprogramming,
refer to Reprogramming the
HomeLink System (page 4-60).



Verify that the programming has
been erased if you resell the vehicle.

1. Press the two outer HomeLink

buttons continuously at the same
time until the indicator light flashes.

1. HomeLink button 3
2. HomeLink button 1

2. Stop pressing the HomeLink

buttons.

▼

Garage Door Two-Way
Communication

The garage door two-way
communication is a function that
communicates with the garage door
opener and indicates whether the
garages door is open or closed using
the indicator lights in the rear view
mirror. It can indicate the status of the
garage door within a range up-to 250
m (820 ft).

NOTE

The communication range may shorten
depending on obstructions.

Programming two-way
communication

Within five seconds after programming
a new HomeLink button, both of the
garage door status indicator lights will
flash rapidly in green indicating that
the garage door two-way
communication has been established.
If the garage door status indicator
lights flash, the two-way
communication programming is
complete.
 
If the garage door status indicator
lights do not flash, the two-way
communication programming is not
completed. For additional HomeLink
information and programming videos,
refer to the following Websites:



www.HomeLink.com



www.youtube.com/
HomeLinkGentex

When Driving

Switches and Controls

4-61

CX-30_8JP5-EA-20K_Edition1_new

2020-7-22 15:50:09