Network Difficulties; 14 - 10; Software Difficulties (MFC-3320CN only)- Page 177

14 - 10

   TROUBLESHOOTING AND ROUTINE MAINTENANCE

Software Difficulties (MFC-3320CN only)

Cannot perform ‘2 in 1 or 4 in 1’ 
printing.

Check that the paper size setting in the application and in the printer 
driver are the same.

Cannot print when using Paint 
Brush.

Try setting the Display setting to ‘256 colors.’

Cannot print when using 
Adobe Illustrator.

Try to reduce the print resolution.

Thick lines and thin lines 
appear alternately. (banding)

1. Open the ‘Basic’ tab in the printer driver.
2. Click ‘Setting’ in the Basic tab of the printer driver.
3. Turn 

Off

 ‘Bi-Directional Printing’ by un-checking it.

(See 

Bi-Directional Printing

 on page 1-7 in Software User’s Guide on the 

CD-ROM.)

There are some dense lines.

Check ‘Reverse Order’ in the Basic tab of the printer driver.

Printing is slow.

In the ‘Color’ tab from the ‘Advanced’ tab in the printer driver, uncheck 
the Color Enhancement.

True2Life

®

 is not working 

properly.

If the image data is not full color in your application (Such as 256 color), 
True2Life

®

 will not work. Please use at least 24 bit color data with the 

True2Life

®

 feature.

‘MFC is Busy’ or ‘MFC 
Connect Failure’ Error 
Message appears.

Make sure the machine is not showing an error message on the LCD.

‘MFC Connect Failure’

If the MFC is not connected to your PC and you have loaded the Brother 
software, the PC will show 'MFC Connect Failure' each time you restart 
Windows

®

. You can ignore this message or you can turn it off as follows.

Double-click "\tool\warnOff.REG" from the supplied CD-ROM.

The Scan key on the MFC's control panel will not work unless you restart 
your PC with the MFC connected.
To turn it back on, Double-click "\tool\WarnOn.REG" from the supplied 
CD-ROM.

PhotoCapture Center

™

 Difficulties (MFC-3320CN only)

Removable Disk does not 
work properly.

a)Have you installed the Windows

®

 2000 update?

If not, do the following:
1. Disconnect the USB cable.
2. Install the Windows 2000

®

 update. Please see the Quick Setup 

Guide. After the installation the PC will be automatically restarted.
3. Wait about 1 minute after you reboot the PC, and then connect the 
USB cable.

b)Take out the media card and put it back in again.
c) If you have tried "Eject", you must take out the media card before you 

continue.

d)If an error message appears when you try to eject the media card, it 

means the card is being accessed.
Wait a while and then try again.

e)If all of the above do not work, please turn off your PC and machine, 

and then turn them on again. 
(You will have to unplug the power cord of the machine to turn it off.)

Network Difficulties

I cannot print over the Network

Make sure that your machine is powered on and is On Line and in 
Ready mode. Press the Test switch. Then the current settings of the 
network are printed.Verify that the cabling and Network connections are 
good. If possible, try connecting the machine to a different port on your 
hub using a different cable.

DIFFICULTY

SUGGESTIONS