CHECK TIRE PRESSURE.- Page 147

2-84

Press the GAGE INFO button until the display shows
BATTERY STATE. If the voltage is normal the display
will show BATTERY STATE NORMAL. If the voltage
drops below 10.5 volts, the display will show BATTERY
STATE LOW. If the voltage is above 16.2 volts, the
display will show BATTERY STATE HIGH. If the display
shows the high or low message, you need to have your
battery and charging system checked.

Press the GAGE INFO button until OIL LIFE INDEX
appears in the display. The OIL LIFE INDEX
NORMAL display will show an estimate of the oil’s
remaining useful life. When the oil life index is less than
10 percent, the display will show OIL LIFE INDEX
CHANGE OIL. When you have the oil changed
according to the maintenance schedule (see
“Maintenance Schedule” in the Index), you will have to
reset the oil life monitor. To reset the Oil Life System
(Index), see “Oil Life System” or “Engine Oil, When to
Change” in the Index.

Press the GAGE INFO button until TIRE PRESSURE
appears in the display. TIRE PRESSURE NORMAL is
displayed when the check tire pressure system believes
your vehicle’s tire pressures are normal. If a potential
tire pressure problem is detected, the display will show
CHECK TIRE PRESSURE.

If you see the CHECK TIRE PRESSURE message, you
should stop as soon as you can and check all your tires
for damage. (If a tire is flat, see “If a Tire Goes Flat” in
the Index.) Also check the tire pressure in all four tires
as soon as you can. See “Inflation 

--

 Tire Pressure” 

and “Check Tire Pressure System” in the Index. 
There are times when you will have to reset (calibrate)
the Check Tire Pressure System. See “Check Tire
Pressure System” in the Index.

RESET: This button, used along with other buttons, will
reset system functions.

ENG/MET (English/Metric): Use this button to change
the display between English and metric units.

DIC messages can be displayed in one of three languages:
English, French or Spanish. The language of the display 
is set by holding the FUEL INFO and RESET buttons
together for five seconds. As the buttons are held, each
language will be displayed for three seconds. Release the
FUEL INFO and RESET buttons when the desired
language is displayed. All DIC messages will now be in
the selected language. Language selection can also be 
done through the DIC Personal Choice Programming. See
“DIC Personal Choice Programming” later in this section.