Canadian Programming; Canadian Owners:; Erasing Channels- Page 167

2-79

3. Return to HomeLink in your vehicle and firmly 

press and release the programmed HomeLink button
three times.

The rolling

-

code garage door opener should now

recognize HomeLink. You may either use HomeLink or
the hand

-

held transmitter to open the garage door.

If after following these instructions, you still have
problems training the garage door opener, contact the
manufacturer of HomeLink at 1

-

800

-

355

-

3515, or on

the internet at www.homelink.com.

Canadian Programming

Canadian Owners: During programming, the
hand

-

held transmitter may automatically stop

transmitting after two seconds. In this case, you should
press and hold the HomeLink button (see Steps 2 and 3
under “Programming the HomeLink Transmitter”) while
you press and repress (cycle) your hand

-

held transmitter

every two seconds until HomeLink is trained.

Operating the HomeLink Transmitter

Press and hold the appropriate button on HomeLink for
at least a half of a second. The indicator light will come
on while the signal is being transmitted.

Erasing Channels

To erase all three programmed channels, hold down the
two outside buttons on HomeLink until the indicator
light begins to flash (approximately 20 seconds).
Release both buttons.

Resetting Defaults

To reset HomeLink to default settings, hold down the
two outside buttons on HomeLink until the indicator
light begins to flash (approximately 20 seconds).
Continue to hold the buttons until the HomeLink
indicator light turns off and then release both buttons.

Accessories

Accessories for HomeLink are available. If you would
like additional information, please contact the
manufacturer of HomeLink at 1

-

800

-

355

-

3515, or 

on the internet at www.homelink.com.