Setting Preset Stations; Finding a Station; AM FM:- Page 227

3-12

DISP (Display): Press this button to display the station
being played or to display the clock. The clock can be
displayed with the ignition on or off.

Finding a Station

AM FM: Press this button to switch between AM, FM1
and FM2. The display shows your selection.

TUNE: Turn this knob clockwise to tune in to the next
station. Turn it counterclockwise to tune into the
previous station.

 SEEK 

: Press the right or left arrow to go to the

next or previous station and stay there. The sound will
mute while seeking. The radio will seek to stations with
a strong signal only.

To scan stations, press one of the SEEK arrows for two
seconds and SCAN will appear on the display. The radio
will go to a station, play for a few seconds, then go on 
to the next station. Press one of the SEEK arrows again
to stop scanning. The sound will mute while scanning. 
The radio will seek to stations with a strong signal only.

To scan preset stations, press one of the SEEK arrows
for four seconds and PSCAN will appear on the display.

The radio will go to a station, play for a few seconds,
then go on to the next station. Press one of the SEEK
arrows again to stop scanning your preset stations. 
The sound will mute while scanning. The radio will 
seek to stations with a strong signal only.

Setting Preset Stations

The six numbered pushbuttons let you return to your
favorite stations. You can set up to 18 stations 
(six AM, six FM1 and six FM2) by performing the
following steps:

1. Turn the radio on.

2. Press AM FM to select the band.

3. Tune in the desired station.

4. Press EQ to select the equalization. It will be stored

with the preset station.

5. Press and hold one of the six numbered pushbuttons.

When you hear the radio produce one beep, release
the pushbutton. Whenever you press that numbered
pushbutton, the station you set will return.

6. Repeat the steps for each pushbutton.