Windshield Washer Fluid; Adding Washer Fluid; How to Check Power Steering Fluid- Page 374

6-29

How to Check Power Steering Fluid

Turn the key off, let the engine compartment cool down,
wipe the cap and the top of the reservoir clean, then
unscrew the cap and wipe the dipstick with a clean rag.
Replace the cap and completely tighten it. Then remove
the cap again and look at the fluid level on the dipstick.

When the engine compartment is hot, the level should be
at the H (hot) mark. When it’s cold, the level should be
at the C (cold) mark. If the fluid is at the ADD mark,
you should add fluid.

What to Use

To determine what kind of fluid to use, see
“Recommended Fluids and Lubricants” in the Index.
Always use the proper fluid. Failure to use the proper
fluid can cause leaks and damage hoses and seals.

Windshield Washer Fluid

What to Use

When you need windshield washer fluid, be sure to read
the manufacturer’s instructions before use. If you will be
operating your vehicle in an area where the temperature
may fall below freezing, use a fluid that has sufficient
protection against freezing. See “Engine Compartment
Overview” in the Index for reservoir location.

Adding Washer Fluid

The windshield washer fluid
reservoir is located in the
engine compartment on the
passenger’s side of the
vehicle, near the fuse and
relay center.

Open the cap with the washer
symbol on it. Add washer
fluid until the tank is full.