Selector 1: ECP mode (Not used.) ; Selector 2: Recovery from Inactive PC Interface (Not used.) ; Selector 3: PC Power-off Recognition Time (Not used.) - Page 303

 App. 

4-40 

Confidential

WSW36 

(Function setting 14)

Selector 

No. 

Function 

Setting and Specifications 

1 

ECP mode*  
(Not used.) 

 0: 

ON 

1: 

OFF 

2 

Recovery from Inactive PC 
Interface  
(Not used.) 

 0: 

Disable 1: 

Enable 

3 

PC Power-off Recognition 
Time  
(Not used.) 

 0: 

Normal 1: 

Long 

4 Not 

used. 

5 

Escape from phase C 

0:  Yes 

1: 

No 

6 

| 

8 

Extension of incoming calling 
signal (CI) frequency band 
specified by selectors 1 
through 4 on WSW14 

No. 6  7  8 

0 0 0 :  0 

(Ignored) 

0 0 1 :  4 

(448 

Hz) 

0 1 0 :  8 

(244 

Hz) 

0 1 1 :  12 

(162 

Hz) 

1 0 0 :  16 

(122 

Hz) 

1 0 1 :  20 

(97 

Hz) 

1 1 0 :  24 

(81 

Hz) 

1 1 1 :  28 

(69 

Hz) 

*ECP (Enhanced Capabilities Port) 

Selector 1:  ECP mode (Not used.) 

The ECP mode enhances the normal bidirectional communications between the machine and the  
connected PC for higher transmission speed. 

Selector 2:  Recovery from Inactive PC Interface (Not used.) 

If the machine recognizes via the STB signal line that the connected PC is powered off, it will turn  
the PC interface outputs Low to protect the PC from hazards that could be caused by weak electric  
current accidentally flown from the machine. 
This selector determines whether or not the machine should recover from the inactive PC interface  
to normal interfacing state upon receipt of data from the PC. 

Selector 3:  PC Power-off Recognition Time (Not used.) 

This selector sets the time length from when the machine detects the PC powered off until it  
recognizes the detected state as power-off.  
If selector 2 is set to "0," it is recommended that selector 3 be set to "1"; otherwise, the machine  
may mistakenly detect PC powered off. 

Selector 5:  Escape from phase C 

This selector determines whether or not the machine will escape from phase C when it detects an  
RTC (Return to Control) in non-ECM mode or an RCP (Return to Control Partial page) in ECM  
mode.