Fig. 5-32 ; Fig. 5-33 ; Fig. 5-34 - Page 150

CHAPTER 5 MAINTENANCE 

5-34 

3. 

  Install the new Transfer Roller by 

holding the Lock Levers of the 
Transfer Roller and adjusting the 
angle of the Transfer Roller Lever 
shafts (both sides) to match the 
Transfer Unit groove.  Set the 
Transfer Roller onto the shafts and 
place the Roller onto the springs as 
shown below: 

Fig. 5-32 

Fig. 5-33 

Fig. 5-34 

4. 

  Lock the new Transfer Roller into place with the Transfer Roller Lock 

Levers. 

5. 

  Close the Rear Access Cover. 

6. 

  Plug the power cord into the power outlet, and then press the Power 

button to turn on the printer.  

7. 

Press any of the Menu buttons (+, – , Set or Back) to turn the printer Off 
line. 

8. 

  Press + or –  until “RESET MENU” appears. 

9. 

  Press Set to proceed to the next menu level, and then press + or –  until 

“PARTS LIFE” appears. 

Transfer Roller

Shaft

Spring

Lock 
Levers