Rainsense II Wipers (If Equipped); The wipers must be turned off when going; through a car wash to avoid damage.- Page 104

2-39

Rainsense

t

 II Wipers (If Equipped)

The moisture sensor is mounted on the interior of the
windshield below the rearview mirror and is used to
automatically operate the wipers. This system operates
by monitoring the amount of moisture build

-

up on 

the windshield. Wipes occur as needed to clear the
windshield depending on the driving conditions and 
the sensitivity setting. In light rain or snow, fewer wipes
will occur. In heavy rain or snow, wipes will occur more
frequently. The system will operate in the delay, low
speed and high speed modes. If the system is left on 
for long periods of time, occasional wipes may occur
without any moisture on the windshield. This is normal
and indicates that the Rainsense system is active.

The Rainsense system is activated by turning the wiper
control band to one of the five sensitivity levels within
the delay area. The delay position closest to OFF/MIST
is the lowest sensitivity setting, level one. This allows
more rain or snow to collect on the windshield between
wipes. You can increase the sensitivity of the system 
and the frequency of wipes by turning the wiper control
band away from you to the higher sensitivity levels. 
The highest sensitivity setting, level five, is closest to
the LO position. A single wipe will occur each time you
turn the wiper control band to a higher sensitivity level
to indicate that the sensitivity level has been increased.

NOTICE:

The wipers must be turned off when going
through a car wash to avoid damage.

The MIST and wash cycles operate as normal and are
not affected by the Rainsense function. The system 
can be overridden at any time by manually changing 
the wiper control to LO or HI speed.

NOTICE:

Do not place stickers or other items on the
exterior glass surface directly in front of the
rainsensor. Doing this could cause the rainsensor
to malfunction.