Setting the Tone; Adjusting the Speakers; P SCAN:- Page 174

3-15

PUSHBUTTONS: The six numbered pushbuttons let
you return to your favorite stations. You can set up to 
18 stations (six AM, six FM1 and six FM2). Just:

1. Turn the radio on.

2. Press the AM

-

FM button to select the band.

3. Tune in the desired station.

4. Press and hold one of the six numbered buttons. The

sound will mute. When it returns, release the button.
Whenever you press that numbered button, the
station you set will return.

5. Repeat the steps for each pushbutton.

If you press and hold pushbutton one with the ignition
on and the radio off, you can change the volume level of
the vehicle’s warning chimes. See “Vehicle Chime
Level” in the Index.

P SCAN: Press this button to listen to each of your
preset stations for a few seconds. The radio will go to
the first preset station, stop for a few seconds, then go
on to the next preset station. Press P SCAN again to stop
scanning. The radio will not stop at a preset station if the
station is weak.

Setting the Tone

BASS: Press this knob lightly so it extends. 
Turn the knob to increase or decrease bass.

TREB: Press this knob lightly so it extends. Turn the
knob to increase or decrease treble. If a station is weak
or noisy, you may want to decrease the treble.

Push these knobs back into their stored positions when
you’re not using them.

Adjusting the Speakers

BAL: Turn the control behind the upper knob to move
the sound to the left or right speakers. The middle
position balances the sound between the speakers.

FADE: Turn the control behind the lower knob to move
the sound to the front or rear speakers. The middle
position balances the sound between the speakers.