DIC Personal Choice Programming- Page 151

2-86

When the STABILITY SYSTEM ACTIVE message 
is on, you should continue to steer in the direction you
want to go. The system is designed to help you in bad
weather or other difficult driving situations by making
the most of whatever road conditions will permit. If the
STABILITY SYSTEM ACTIVE message comes on,
you’ll know that something has caused your vehicle to
start to spin, so you should consider slowing down.

DIC Personal Choice Programming

The DIC can be used to program the following personal
choice features available with your vehicle:

D

Automatic Door Locks

D

Window Lockout

D

Security Feedback

D

Delayed Locking

D

Perimeter Lighting

D

Memory Seats

D

Tilt Mirrors (If Equipped)

D

Driver ID ON/OFF

For vehicles not equipped with a DIC, see “Personal
Choice Programming” in the Index.

The personal choice settings displayed on the DIC 
are determined by the transmitter used to enter the
vehicle. Each remote keyless entry transmitter was
pre

-

programmed to belong to DRIVER 1 or DRIVER 2

and is numbered on the back. After the button with the
unlock symbol on a remote keyless entry transmitter is
pressed and the ignition is in RUN, the DIC will display
the identified driver and recall the settings previously
programmed for that driver. The settings can also be
recalled by briefly pressing one of the MEMORY
buttons located on the driver’s door.

If you unlock the vehicle using your door key instead 
of your transmitter, the DIC will not change drivers and
will recall the information from the last transmitter used
or the last driver using the memory seat controls. If this
happens and you were not the last driver of the vehicle,
simply press your correct driver number on the memory
seat controls or press the button with the unlock symbol
on your remote keyless entry transmitter.