Erasing Channels; Accessories- Page 130

2-65

3. Return to the HomeLink Transmitter in your 

vehicle and firmly press and release the HomeLink
Transmitter button you have already programmed for
two to three seconds. Press and release the button
again (you may need to do this step up to three
times) to make sure that the HomeLink Transmitter
has been trained to the garage door opener motor
head unit. Check that the training was successful.

The garage door opener should now recognize the
HomeLink Transmitter. You may either use the
HomeLink Transmitter or the hand

-

held transmitter 

to open the garage door.

If after following these instructions, you still 
have problems training the garage door opener, 
contact the HomeLink

R

 Transmitter manufacturer 

at 1

-

800

-

355

-

3515.

Erasing Channels

To erase all three programmed channels, hold down the
two outside buttons until the indicator light begins to
flash (after 20 seconds). Release both buttons.

Accessories

Accessories for the HomeLink Transmitter are available
from the manufacturer of the unit. If you would like
additional information, please call 1

-

800

-

355

-

3515.