Vehicle Customization; Driver Information Center (DIC) ; ZONE # PRESS & HOLD SET TO CHANGE:- Page 197

2-109

ZONE # PRESS & HOLD SET TO CHANGE: This
display mode will be displayed when you are manually
calibrating the system. The current zone number for
compass variance will be displayed in place of the 
# symbol. Use the SET button to select the zone number
from the graphic shown to select the current area of the
country that you are driving in.

PRESS SET TO CALIBRATE COMPASS: After
selecting your zone, press the MODE button and this
will be displayed on the DIC. Press the SET button and
complete three 360 degree turns in an area free from
large metal objects.

The following two messages will toggle in the display
until you calibrate the compass:

D

DRIVE VEHICLE IN CIRCLE

D

CALIBRATING COMPASS

When calibration is complete, the display will return to
its normal mode.

Driver Information Center (DIC) 
Vehicle Customization

The DIC is used to program the choices of two drivers.
The drivers are recognized as DRIVER 1 and
DRIVER 2 in the DIC display. You will let the DIC
know which driver you are by using your remote keyless
entry transmitter. Each remote keyless entry transmitter
was pre

-

programmed to belong to DRIVER 1 or

DRIVER 2. Each transmitter may be programmed
differently for each driver’s preferences.

After you press the LOCK button on your transmitter
and the ignition key is in ON, the DIC will display the
identified driver number. The vehicle will also recall the
vehicle customization features that were last
programmed to correspond to your transmitter.

If you unlock your vehicle using your key instead of
your transmitter, the DIC will not change drivers and
your vehicle will recall the information from the last
transmitter used.