Carefully pull the end of the thread that was ; passed through the eye of the needle.; Pull out about 10-15 cm (approx. 4-6 - Page 63

UPPER THREADING

Ge
tting

 Re
ad

y

49

1

n

Carefully pull the end of the thread that was 
passed through the eye of the needle.

*

If a loop was formed in the thread passed through 
the eye of the needle, carefully pull on the loop of 
thread through to the back of the needle.

o

Pull out about 10-15 cm (approx. 4-6 
inches) of the thread, and then pass it under 
the presser foot toward the rear of the 
machine.

o

Raise the presser foot lever if the presser foot is 
lowered.

a

About 10-15 cm (approx. 4-6 inches)

Using the Twin Needle Mode 

The twin needle can only be used for patterns that 

show 

 after being selected. Before you select a 

stitch pattern, make sure the stitch can be sewn in 
the twin needle mode (refer to the “STITCH 
SETTING CHART” at the end of this manual).

Note

• Pulling the loop of thread gently will avoid 

needle breakage.

Memo

• If the needle could not be threaded or the 

thread was not passed through the needle 
bar thread guides, perform the procedure 
again starting from step 

c

.

Then, pass the thread through the eye of the 
needle after step 

i

.

Note

• Some needles cannot be threaded with the 

needle threader. In this case, instead of 
using the needle threader after passing the 
thread through the needle bar thread guide 
(marked “6”), manually pass the thread 
through the eye of the needle from the front.

 CAUTION

• Twin needle (part code XE4963-001) is 

recommended for this machine. Contact your 
authorized dealer for replacement needles 
(size 2.0/11 is recommended).

• Be sure to set the twin needle mode when 

using the twin needle. Using the twin needle 
while the machine is in single needle mode 
could cause the needle to break, resulting in 
damage.

• Do not sew with bent needles. The needle 

could break and cause injury.

• When using the twin needle, it is 

recommended to use presser foot “J”.

• When the twin needle is used, bunched 

stitches may occur depending on the types of 
fabric and thread that are used.
Use monogramming foot “N” for decorative 
stitches.

• Before changing the needle or threading the 

machine, be sure to press

 on the LCD 

Screen, otherwise injuries may occur if the 
“Start/Stop” button or any other button is 
pressed and the machine starts sewing.