Pull the thread off the spool. Pass the thread ; from the back to the front through the ; thread guides at the top.- Page 67

UPPER THREADING

Ge
tting

 Re
ad

y

53

1

c

Pull the thread off the spool. Pass the thread 
from the back to the front through the 
thread guides at the top.

d

Pass the thread through the machine's 
thread guide from the right to the left.

a

Thread guide

e

Thread the machine according to the steps 

f

 to 

o

 of “Upper Threading” on page 46.

Using Threads that Unwind 
Quickly

■

Using the Spool Net

If using transparent nylon monofilament thread, 
metallic thread, or other strong thread, place the 
included spool net over the spool before using it. 
When using specialty threads, threading must be 
done manually.
If the spool net is too long, fold it once to match it to 
the spool size before placing it over the spool.

Note

• When using 2 spools of thread, make sure 

that both spools are feeding in the same 
direction.

• Make sure that the spools do not touch each 

other, otherwise the thread will not feed off 
smoothly, the needle may break, or the 
thread may break or become tangled. In 
addition, make sure that the spools do not 
touch the telescopic thread guide at the cen-
ter.

• Make sure that the thread is not caught 

under the spool.

Note

• Guide the thread so that it does not become 

entangled with the other thread.

• After feeding the thread as instructed, wind 

any excess thread back onto the spool, oth-
erwise the excess thread will become tan-
gled.

Memo

• When threading the spool with the spool net 

on, make sure that 5-6 cm (approx. 2 - 2-1/2 
inches) of thread are pulled out.

• It may be necessary to adjust the thread ten-

sion when using the spool net.

a

Spool net

b

Thread spool

c

Spool pin

d

Spool cap