Reloading using the FTP Protocol from a command prompt; Reloading using the FTP Protocol from a - Page 165

A - 6 APPENDIX

NC9100h_FM6.0

5

Netware GET from a server

You must have a Netware server on your network (running IPX/
SPX) and you must store the new firmware file in the SYS/Login 
directory of the server. In this case, your PC makes the Print/Fax 
server read the firmware data from the assigned Netware 
server, the Print/Fax server attaches to the Netware server and 
reads the firmware itself.

Reloading using the FTP Protocol from a 
command prompt

By specifying the Print/Fax server password as the username when 
logging on, it becomes possible to upgrade the firmware of the Print/
Fax server or printer (if supported). The following example assumes 
that the Print/Fax server password is 

cambridge

D:\>ftp
ftp> open 220.0.250.200
Connected to 220.0.250.200.
220 FTP print service:V-1.05/Use the network 
password for the ID if updating.
User (220.0.250.200:(none)): cambridge
230 User cambridge logged in.
ftp> bin
200 Ready command OK.
ftp> hash
Hash mark printing on  ftp: (2048 bytes/hash mark) .
ftp> send brnt261.blf
200 Ready command OK.
150 Transfer Start
#################################################
########
#################################################
#################################################
#################################################
###########################
226 Data Transfer OK/Entering FirmWareUpdate mode.
ftp: 1498053 bytes sent in 8.52Seconds 
175.77Kbytes/sec.
ftp> close
226 Data Transfer OK.
ftp> quit

After sending firmware to the machine, do not turn off the 
machine until after the machine has performed an automatic 
restart.