After removing the brim holder, unlock the ; snap lock of the clamping frame, remove the ; clips, and then remove the cap.- Page 239

Using the Optional Cap Frame

 237

7

—————————————————————————————————————————————————————————————————————————————————————

2

After removing the brim holder, unlock the 
snap lock of the clamping frame, remove the 
clips, and then remove the cap.

1

Brim holder

2

Snap lock

3

Clips

Installing the embroidery 
frame holder

After embroidering using the cap embroidery frame 
is finished, remove the needle plate spacer and cap 
frame driver, and then re-attach the embroidery 
frame holder.

1

Remove the needle plate spacer.

1

Needle plate spacer

2

Loosen the two lower thumb screws.

1

Thumb screws

3

Remove the two upper thumb screws

1

Thumb screws

4

Remove the cap frame driver.

Note

●

Be careful that the cap frame driver does 
not hit any nearby parts, such as the 
presser foot.

5

With the hole on the sweat guard holder 
aligned with the centerline of the guiding 
plate, insert the two thumb screws removed 
in step 

3

 into the holes at the top, and then 

tighten the thumb screws.

1

Hole on the sweat guard holder

2

Centerline of guiding plate

3

Holes on the top

• Insert the thumb screws into the holes 

where the cap frame driver that was 
originally installed (holes that the thumb 
screws were removed from in step 

2

 on 

page 227).

X

The movable section of the cap frame 
driver is secured.