Getting false thread breakage error; Thread tension changed suddenly; The frame came out from the carriage- Page 82

EMBROIDERING TUTORIAL 

—————————————————————————————————————————————————————————————————

80

■

Getting false thread breakage error

- Check that the position of the upper thread is 

under the upper thread guide plates. (Refer to 
page 56.)

- Check that the position of the upper thread is 

around the thread tension disc. (Refer to 
page 57.)

1

Upper thread guide plates

2

Thread tension disc

■

Thread tension changed suddenly

- Thread is caught on a rough edge of the spool 

of upper thread.

- Upper thread is caught under the spool of 

thread.

- The thread dust or lint is gathered under the 

bobbin’s tension spring.

■

The frame came out from the carriage

Make sure that the positioning pins are placed 
into the frame’s positioning slot and hole. (Refer 
to page 49.)
To insure proper registration of pattern for 
embroidery, turning off the machine and turning 
it back on will allow the embroidery arm to reset 
it’s registration points.

■

Cancel the current design and start again

Select the “Home” key on the upper right of the 
screen. The pattern and all information will be 
deleted. (Refer to page 70.)

USB connectivity

You can perform many functions using the USB 
ports on the machine. Connect the appropriate 
devices according to the feature of each ports.

1

Primary (top) USB port for media or card 
Reader/USB card writer module* (USB2.0)

* If you have purchased the PE-DESIGN Ver5 or 

later, PE-DESIGN Lite or PED-BASIC, you can 
plug the included USB card writer module into 
the machine as an embroidery card reader, and 
recall patterns.

2

USB port for mouse (USB1.1)

3

USB port for computer

Note

●

The processing speed may vary by port 
selection and quantity of data.

●

Do not insert anything other than USB 
media into the USB media port. 
Otherwise, the USB media drive may be 
damaged.

■

Using USB media or embroidery card Reader/
USB card writer module*

When sending or reading patterns using the USB 
media or the embroidery card Reader/USB card 
writer module*, connect the device to the 
primary (top) USB port.
The primary (top) USB port processes the data 
faster than the other ports.

* If you have purchased the PE-DESIGN Ver5 or 

later, PE-DESIGN Lite or PED-BASIC, you can 
plug the included USB card writer module into 
the machine as an embroidery card reader, and 
recall patterns.