Setting up the machine; Make sure that all packing tape affixed to the ; machine is peeled off and that all packing - Page 28

GETTING READY 

————————————————————————————————————————————————————————————————————————

26

Setting up the machine

When setting up the machine, adjust the legs so 
that the machine is steady.

1

Make sure that all packing tape affixed to the 
machine is peeled off and that all packing 
material is removed.

2

Set up the machine while making sure that 
there is sufficient space around it.

3

Adjust the legs so that the machine is steady.

Use the included wrench to loosen the lock 
nut on the leg that you wish to adjust.

1

Lock nut

2

Adjustable foot nut

X

The foot can be turned.

4

Use the included wrench to turn the 
adjustable foot nut on the foot.

Turning the nut in direction 

1

 lengthens the 

leg; turning the nut in direction 

2

 shortens 

the leg.

1

Adjustable foot nut

• Adjust all four legs so that they securely 

contact the desk or table.

5

After adjusting the legs to the desired length, 
use the included wrench to tighten the nuts.

1

Lock nut

6

Press down on each corner of the 
embroidery machine to check that it is 
stable.

If it is still unstable, perform steps 

3

 through 

5

 again to adjust the legs.

More than 
50 mm
(2 inches)

589 mm
(23-3/16 
inches)

More than 
350 mm
(13-3/4 inches)

More than 
250 mm
(9-7/8 inches)

512 mm 
(20-5/32 inches)

More than 
250 mm
(9-7/8 inches)