Preparing the thread guide ; Using the Phillips screwdriver, loosen the ; screws on the left side of the thread guide - Page 30

GETTING READY 

————————————————————————————————————————————————————————————————————————

28

Preparing the thread guide 
assembly

Raise the thread guide assembly. Locate the 
included Phillips screwdriver.

1

Using the Phillips screwdriver, loosen the 
screws on the left side of the thread guide 
assembly support so that the thread guide 
assembly can be raised.

Remove screw 

1

, and then turn screw 

2

 three or 

four times to loosen it.

1

Remove the screw.

2

Turn the screw three or four times to loosen it.

2

Raise thread guide into position and tighten 
screw 

2

 on the left. Insert screw 

1

 into 

right side of the thread guide assembly 
support and tighten.

1

Insert screw and tighten.

2

Tighten screw.

3

Using the Phillips screwdriver, loosen the 
screws on the left and right sides of the 
thread guide assembly and lift up the thread 
guide so that it is level.

1

Loosen Screws

4

Tighten the screws on the left and right sides 
of the thread guide assembly.

Note

●

If the screws are not loosened enough, it 
may not be easy to move the thread guide 
assembly support and the thread guide. 
Do not apply extreme force when moving 
the thread guide assembly support and the 
thread guide. Be sure that the screws are 
loosened well enough before moving 
these parts.

●

Be sure to tighten each screw well enough 
that the thread guide assembly support 
and the thread guide are secured.