Headlamp Aiming- Page 274

6-32

5. Remove the rubber access cover (from behind the

bulb you are replacing).

6. Turn the bulb socket one

-

quarter turn and remove it

from the lamp.

7. Lift the plastic locking tab on the electrical

connector and pull the connector from the headlamp
bulb socket.

8. Connect the new headlamp bulb to the wiring

harness, making sure the connector tab snaps 
into place.

9. Insert the bulb socket into the headlamp assembly.

10. Reverse all steps to reassemble the headlamp

assembly, then check the lamps.

Headlamp Aiming

Your vehicle has a headlamp system equipped with
horizontal and vertical aim indicators. The aim has been
pre

-

set at the factory and should need no further

adjustment. This is true even though your vertical and
horizontal aim indicators may not fall exactly on the 
“0” (zero) marks on their scales.

If your vehicle is damaged in an accident, the headlamp
aim may be affected. Aim adjustment may be necessary
if it is difficult to see lane markers (for horizontal aim),
or if oncoming drivers flash their high beams at you (for
vertical aim). If you believe your headlamps need to be
re

-

aimed, we recommend that you take it to your dealer

for service; however, it is possible for you to re

-

aim

your headlamps as described in the following procedure.