2014 Dodge Charger SRT Owner Manual
To Disarm The System
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
Table of Contents
Detailed Information for 2014 Dodge Charger SRT Owner Manual
Summary of Contents for 2014 Dodge Charger SRT Owner Manual
Page 22: To Disarm The System
2. Perform one of the following methods to lock the
vehicle:
•
Push LOCK on the interior power door lock switch
with the driver and/or passenger door open.
•
Push the LOCK button on the exterior
Page 23: Tamper Alert
NOTE:
•
The driver’s door key cylinder and the trunk button on
the RKE transmitter cannot arm or disarm the Vehicle
Security Alarm.
•
When the Vehicle Security Alarm is armed, the interior
power door lock switches
Page 24: ILLUMINATED ENTRY — IF EQUIPPED
ILLUMINATED ENTRY — IF EQUIPPED
The courtesy lights will turn on when you use the
Remote Keyless Entry (RKE) transmitter to unlock the
doors or open any door.
This feature also turns on the
Page 25: REMOTE KEYLESS ENTRY (RKE)
REMOTE KEYLESS ENTRY (RKE)
The RKE system allows you to lock or unlock the doors,
open the trunk, or activate the Panic Alarm from dis-
tances up to approximately 66 ft (20 m)
Page 26: To Unlock The Doors
To Unlock The Doors
Push and release the UNLOCK button on the RKE
transmitter once to unlock the driver’s door or twice
within five seconds to unlock all doors. The turn signal
lights will
Lists of information found in 2014 Dodge Charger SRT Owner Manual
- 2. Perform one of the following methods to lock the vehicle: • Push LOCK on the interior power door lock switch with the driver and/or passenger door open.
- 3. If any doors are open, close them.
- Push LOCK on the interior power door lock switch with the driver and/or passenger door open.
- Push the LOCK button on the exterior Passive Entry Door Handle with a valid Key Fob available in the same exterior zone (refer to ⬙ Keyless Enter-N-Go™ ⬙ in ⬙ Things To Know Before Starting Your Vehicle ⬙ for further information).
- Push the LOCK button on the Remote Keyless Entry (RKE) transmitter.
- Press the UNLOCK button on the Remote Keyless Entry (RKE) transmitter.
- Grasp the Passive Entry Unlock Door Handle if equipped, refer to “Keyless Enter-N-Go™” in “Things To Know Before Starting Your Vehicle” for further information.
- Cycle the vehicle ignition system out of the OFF position.
- For vehicles equipped with Keyless Enter-N-Go™, press the Keyless Enter-N-Go™ START/STOP button (requires at least one valid Key Fob in the vehicle).
- For vehicles not equipped with Keyless Enter-N-Go™, insert a valid key into the ignition switch and turn the key to the ON position.
All trademarks are property of their respective owners. Tightrope
Interactive