Fresh Manuals
Brands
Dodge
Automobiles
Charger

2014 Dodge Charger SRT Owner Manual

General Information

Separating The RKE Transmitter Case

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
OCCUPANT RESTRAINTS
Child Restraints
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Uconnect® PHONE (4.3)
Uconnect® PHONE (8.4/8.4N)
ADAPTIVE CRUISE CONTROL (ACC) — IF EQUIPPED
UNDERSTANDING YOUR INSTRUMENT PANEL
STARTING AND OPERATING
MAINTAINING YOUR VEHICLE
MAINTENANCE PROCEDURES

Detailed Information for 2014 Dodge Charger SRT Owner Manual

Summary of Contents for 2014 Dodge Charger SRT Owner Manual

Page 29: General Information
2. Insert the tip of the emergency key or a #2 flat blade screwdriver into the slot and gently pry the two halves of the RKE transmitter apart. Make sure not to
Page 30: REMOTE STARTING SYSTEM — IF EQUIPPED
NOTE: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. If your RKE transmitter fails to operate from a normal distance, check for
Page 31: Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) — If Equipped
• Battery at an acceptable charge level • RKE panic button not pushed • System not disabled from previous remote start event • Vehicle security alarm not active • Ignition in OFF position WARNING! • Do not start or run an engine
Page 32: To Enter Remote Start Mode
To Enter Remote Start Mode Push and release the REMOTE START button on the RKE transmitter twice within five sec- onds. The vehicle doors will lock, the parking lights will flash and the horn
Page 33: Cancel Remote Start
equipped). Then, prior to the end of the 15-minute cycle, push and release the START/STOP button. NOTE: The message “Push Start Button” will display in the EVIC until you push the START button. Cancel Remote

Lists of information found in 2014 Dodge Charger SRT Owner Manual

  • 2. Insert the tip of the emergency key or a #2 flat blade screwdriver into the slot and gently pry the two halves of the RKE transmitter apart.
  • 3. Remove the battery by turning the back cover over (battery facing downward) and tapping it lightly on a solid surface such as a table or similar, then replace the battery.
  • 4. To assemble the RKE transmitter case, snap the two halves together.
  • This device may not cause harmful interference.
  • This device must accept any interference received, including interference that may cause undesired op- eration.