Fresh Manuals
Brands
Dodge
Automobiles
Charger

2014 Dodge Charger SRT Owner Manual

Reprogramming A Single HomeLink® Button

not release the button.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
OCCUPANT RESTRAINTS
Child Restraints
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Uconnect® PHONE (4.3)
Uconnect® PHONE (8.4/8.4N)
ADAPTIVE CRUISE CONTROL (ACC) — IF EQUIPPED
UNDERSTANDING YOUR INSTRUMENT PANEL
STARTING AND OPERATING
MAINTAINING YOUR VEHICLE
MAINTENANCE PROCEDURES
Page 294

Detailed Information for 2014 Dodge Charger SRT Owner Manual

Summary of Contents for 2014 Dodge Charger SRT Owner Manual

Page 294: Reprogramming A Single HomeLink® Button
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view. 3. Continue to push
Page 295: Using HomeLink®
3. Without releasing the button proceed with “Canadian/ Gate Operator Programming” step 2 and follow all remaining steps. Using HomeLink® To operate, push and release the programmed HomeLink® button. Activation will now occur for the programmed device (i.e., garage door opener, gate opera- tor, security
Page 296: General Information
WARNING! Vehicle exhaust contains carbon monoxide, a danger- ous gas. Do not run your vehicle in the garage while programming the transceiver. Exhaust gas can cause serious injury or death. WARNING! Your motorized door or gate
Page 297: POWER SUNROOF — IF EQUIPPED
NOTE: • The transmitter has been tested and it complies with FCC and IC rules. Changes or modifications not ex- pressly approved by the party responsible for compli- ance could void the user’s authority to
Page 298: Opening Sunroof — Express
WARNING! • Never leave children unattended in a vehicle, or with access to an unlocked vehicle. Never leave the Key Fob in or near the vehicle, or in a location accessible to children. Do not

Lists of information found in 2014 Dodge Charger SRT Owner Manual

  • 2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view.
  • 3. Continue to push and hold the HomeLink® button, while you press and release (“cycle”) your hand-held transmitter every two seconds until HomeLink® has successfully accepted the frequency signal.
  • 4. Watch for the HomeLink® indicator to change flash rates.
  • 5. Push and hold the programmed HomeLink® button and observe the indicator light.
  • 1. Cycle the ignition to the ON/RUN position.
  • 2. Push and hold the desired HomeLink® button until the indicator light begins to flash after 20 seconds.
  • If the indicator light stays on constantly, program- ming is complete and the garage door/device should activate when the HomeLink® button is pushed.
  • To program the two remaining HomeLink® buttons, repeat each step for each remaining button.