the thread tension may be wrong or the needle may break and cause injury. - Page 350

ERROR MESSAGES

336

This message is displayed 
when the automatic needle 
threading button is pushed 
while twin needle sewing is 
set.

This message is displayed 
when the “Start/Stop” button 
is pressed before the edge of 
the fabric is detected. To 
detect the edge of the fabric 
using the built-in camera, 

press 

, raise the 

presser foot, and then 
perform the operation again. 
(see page 138)

This message is displayed 
when the built-in camera 
cannot detect the edge of the 
fabric. 
If this message appeared 
after sewing has reached 1 to 
2 cm (about 3/8 to 3/4 inch) 
from the edge of the fabric, 
refer to step 

m

 in “Edge 

Sewing” on page 144.
If this message appeared 

during edge sewing, the edge 

of the fabric cannot be 

detected by the built-in 

camera. Press 

, raise 

the presser foot, raise the 

needle if it is lowered, and 

then perform the procedure 

described in “Edge Sewing” 

on page 140 starting from 

step 

f

.

If this error message appears 
again, sew without using 
edge sewing function.

This message appears when 

 or 

 is 

pressed to delete the settings 
for a utility stitch. To delete 
the selected settings, press 

.

This message is displayed 
when an unusable 
embroidery card is inserted. 

This message is displayed 
when the “Reverse/
Reinforcement Stitch” button 
is pushed while the 
embroidery unit is attached.

This message is displayed 
when the foot controller is 
pressed while the embroidery 
unit is attached and machine 
is set up for embroidering.

This message is displayed 
when the patterns you are 
editing take up too much 
memory, or if you are editing 
too many patterns for the 
memory.