7-10-1. Installing the feed plate; 7-10-1. Installing the feed plate ; End feed plate installation mode - Page 103

7. ADJUSTMENT 

BAS-311G, BAS-326G 

96

7-10-1. Installing the feed plate 

1 

MENU indicator switches off

THREAD/CLAMP indicator illuminates

While pressing the THREAD/CLAMP key, turn on the power 
switch. 
*  Keep pressing the THREAD/CLAMP key until the model 

name is displayed and the buzzer beeps once. 

•

  "CLMP" will appear in the menu display. 

2 

Depress the foot switch to the 2nd step. 
(If using a two-pedal foot switch, lower the work clamp before 
depressing the start switch.) 

•

  After the home position is detected and the work clamp drops, the 

feed mechanism will move to the feed plate installation position and 
then the work clamp will rise. 

3 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Use a 2 mm diameter pin to align the holes in the X feed bracket (1) and the needle plate (2) with the two holes in the 
feed plate (3), and then tighten the two bolts (4). 

NOTE:

Install the feed plate so that the surface with the index mark is facing upward. 

4 

End feed plate installation mode 

Turn off the power. 
 
 

4421Q

All indicators switch off 

2nd step 

5005Q

4441Q

5006Q

Index 

mark