3-11. Updating the control program; 3-11. Updating the control program ; 3. READING / WRITING DATA - Page 37

3. READING / WRITING DATA 

30

BAS-311G, BAS-326G 

3-11. Updating the control program 

1 

Select the [r 7] data read/write mode. 

2 

Press the R/W key. 
 
 
 
 

•

  [-SyS] will be displayed for a certain amount of time, and 

then the display will change to [ vEr], and after that the 
version number of the control program that is stored on 
the CF card will be displayed. 

3 

Press the R/W key. 
 

•

 [  P] will flash in the PROGRAM No. display and the 

control program will be updated.

NOTE: 

If the filename and folder name for the control program 
are incorrect, error [E421] will be displayed. 

4 

When [ End] is displayed, the process is complete. 
Turn off the power switch, remove the CF card, and then 
close the cover of the CF slot. 

NOTE: 

•

 Version updating may take about 3 

−

 10 minutes. 

(The time taken will vary depending on the 
manufacturer and storage capacity of the CF card 
being used. ) 

•

 Never remove the CF card or turn off the power 

switch while reading of the CF card is in progress. 

<Restoring the control program if an error occurs during updating> 

If the version updating did not complete normally, such as because of a power outage, the sewing machine will not operate 
correctly.  
If this happens, restore the control program by the following procedure. 
1.  Insert the CF card containing the control program data into the CF card slot. 
2.  Turn on the power switch. The operation panel will switch off and the version updating will be carried out. 
3.  When the initial screen turns back on, the updating is complete. Turn off the power switch, remove the CF card, and 

then close the cover of the CF slot. 

5060Q

4581Q

4585Q