Troubleshooting; Overview; Installation Problems- Page 116

TROUBLESHOOTING 11 - 1

11

11

Troubleshooting

Overview

This chapter describes procedures for troubleshooting problems you 
may encounter with a Brother print server, it is divided into the 
following sections: 

1

Installation Problems

2

Intermittent Problems 

3

Protocol-Specific Troubleshooting

Installation Problems

If you cannot print over the network, check the following:

1

Make sure that the printer is powered on, is on-line and ready to 
print.

Verify that the printer and the configuration are good by printing 
the printer settings page. Refer to the Quick Setup Guide. If the 
test fails, check:

a

If the LED is not blinking after connected to the network, then 
the network firmware settings may be corrupted.

b

In this event, try to restore the factory default settings of the 
print server by pressing the Network Test Button on the back 
of the printer for more than 5 seconds. Once you have done 
that, turn off the printer and then on again. You can check the 
settings by printing the printer settings page.